Al contenuto della pagina

Supporto stativo per diffusori monitor

  • Altezza regolabile da 80 a 113 cm
  • Stabile struttura a 3 tubi
  • Superficie di ciascun piano d'appoggio: 30 x 30 cm
  • Base: 35 x 35 cm con piedini regolabili
  • Tubi in alluminio anodizzato nero e piastre laminate nere
  • Capacità massima di carico: fino a 50 kg
  • Made in Germany
  • Prezzo per coppia
  • In catalogo dal Luglio 2015
  • Numero di articolo 367870
  • Unità incluse 1 Paio
  • Tipo Stand per monitor
  • Altezza 800 mm – 1130 mm
€ 233
Tutti i prezzi incl. IVA
Disponibile
1

66 Valutazioni dei clienti

4.3 / 5

stabilitá

Qualità

39 Recensioni

H
Sono ok ma...
Hellothere! 24.04.2020
Utilizzo gli stand in questione per appoggiare due nearfield da 8 pollici molto pesanti.
La regolazione dell'altezza è ottima e regge perfettamente.
In generale la qualità costruttiva è ottima.

L'unico problema di questi stand è che se per sbaglio urtate anche leggermente contro gli stand stessi o comunque gli speaker, questi ultimi cambieranno posizionamento perché il design a 3 colonne degli stand non è abbastanza solido e la base dove poggiano gli speaker può ruotare in maniera abbastanza evidente.

Peccato perché è un bel prodotto sia esteticamente che funzionalmente.
Qualità
stabilitá
0
0
Segnala un abuso

Segnala un abuso

L
Stand perfetti ad un prezzo sensato
LMR9 02.12.2017
Molto solidi e decisamente un grado di sorreggere altoparlanti molto più pesanti e molto più grandi degli stand stessi (non mentono sui 50 kg!).

Non è immediata la messa in bolla ma con un pizzico di pazienza si fa e si ottiene una stabilità ottimale. Esteticamente oserei dire che stanno bene con qualunque setup non attirando troppo l' attenzione. Ottimo prodotto per tutti e soprattutto per chi ha un budget risicato ma non vuole rinunciare alla stabilità.

Non generano alcuna risonanza udibile dovuta alla struttura tubolare.
Qualità
stabilitá
0
0
Segnala un abuso

Segnala un abuso

google translate gb
Purtroppo si è verificato un errore, ti preghiamo di riprovare più tardi.
FS
Monitor Stands
Fab S. 10.09.2020
I use these stands to hold up a pair of Adam A7Xs with isoAcoustics decouplers.

PROS
-The assembly process is quick and the build quality is nice.

-Metal parts feel sturdy and top/bottom plates are nicely finished.

-The height is adjustable: you have to tighten a set of 3 screws for each stand.

-There are four adjustable rubber feet bolted-in that help keeping the stand well balanced in case of uneven floors.

CONS
-The stands wiggle a bit if pushed/bumped (especially if you raise the poles a lot) but nothing to worry about too much. If that "heavy greek column" feel is mandatory for you, perhaps you won't be 100% happy.

-It's a bit tricky to match the height perfectly between the 3 poles. A spirit level of sort will come handy.

OVERALL: 8/10
Qualità
stabilitá
3
2
Segnala un abuso

Segnala un abuso

google translate gb
Purtroppo si è verificato un errore, ti preghiamo di riprovare più tardi.
B
Not great, but not bad either
BasSine 19.04.2023
These are rated to 50kg and i have made good use of that limit with a stacked setup (decoupled with isoacoustics) weighing 37kg approx.

The stands themselves seem very capable of taking this weight and I have no doubt that they could handle 50kg quite safely.

Triple leg design does give good confidence of strength.

The adjustable range is fairly generous, although I use them on their lowest setting.

Downsides:

Can’t be filled with sand and therefore regardless of weight of monitors the metal poles resonate quite badly even with the clamps fully tightened when used at the rated 80cm.

I think this is the inner tube for height adjustment contacting inside the outer tube for the actual stand… maybe it can be cut down to prevent it - but I certainly won’t do that and invalidate any warranties.

Also of note, the finish of one of the two stands was well below par - the side trim pretty badly glued on with visible excess white glue all over (on a black stand). I managed to clean most of it off but the trim is obviously misaligned on close inspection. Not a big deal though.

This along with a lack of stability (it can wobble a little), just makes it fall short of a great stand, but it is capable of holding heavy weights at A range of heights.

Unfortunately despite the range of features the stand fell a little below my expectations.
Qualità
stabilitá
2
0
Segnala un abuso

Segnala un abuso