Al contenuto della pagina

Trasformatore e isolatore a 2 canali

  • Alloggiamento in alluminio pressofuso
  • Ingressi e uscite a jack
  • Ideale per eliminare i disturbi dai segnali stereo
  • 5 anni di garanzia del produttore!
  • In catalogo dal Aprile 2010
  • Numero di articolo 246705
  • Unità incluse 1 Pezzo
  • Unità multi-canale Si
  • Canali 2
  • Attivo / Passivo Passivo
  • 19" No
  • Pad intercambiabile No
  • Switch Gnd/Lift Si
  • Alimentazione a batterie No
  • Speaker Simulation No
€ 114
Tutti i prezzi incl. IVA
Disponibile
1

58 Valutazioni dei clienti

4.7 / 5

Caratteristiche

Suono

Qualità

34 Recensioni

FP
Isolatore che non "Isola" correttamente
Francesco Penolazzi 06.10.2023
Segnalo che il telaio del Palmer PLI-05 Isolation Box è messo a terra sull'uscita invece che sull'ingresso. Se l'isolatore se venisse fissato ad struttura metallica dove è fissato anche l'apparato da isolare (Rack), allora l'interruttore "GND Lift" sarà inefficace perchè la massa dell'ingresso verrà ricollegata con quella dell'uscita attraverso il telaio. Per completezza ma non meno importante, aggiungo che i trasformatori non hanno la schermatura magnetica col Mumetal. Purtroppo non ho avuto tempo per fare misure strumentali.
Prodotto con telaio pesante ma con trasformatori "leggeri", a mio giudizio, non professionale.
Caratteristiche
Suono
Qualità
3
0
Segnala un abuso

Segnala un abuso

google translate gb
Sfortunatamente si è verificato un errore, La preghiamo di riprovare più tardi.
H
Very sturdy and minimal tone loss
Hansi85 22.02.2024
I got the Palmer PLI-05 to compare with the Radial SB-6 and Behringer HD400 for the purpose of removing extra noise from my pedalboard and amp setup. I am using a HX Effects in 4CM which is already notorious for adding some hiss but also ran into an issue of ground loop buzz in the FX loop of my amp (a modded Marshall). I wish the Palmer also had an option to change polarity of the other channel if needed and it would be bonus to be able to lift the ground on individual channels but nevertheless the isolator works fine for my use. Out of the three options it was the only one that did not show a significant drop in level and I could not really hear any tone loss to worry about. For my purposes the Palmer is the winner.
Caratteristiche
Suono
Qualità
2
0
Segnala un abuso

Segnala un abuso

google translate gb
Sfortunatamente si è verificato un errore, La preghiamo di riprovare più tardi.
u
Good enough to be part of my gears
unhappyveryunhappywhereisthebasket 15.05.2023
I got some troubles with a hand made crossover/preamp, I used this line isolator to reduce to the maximum the interferences and it works !!
Of course the ground noise couldn't be wiped out but everybody could say that with these gears the whole Sound system sounds better !
Caratteristiche
Suono
Qualità
2
0
Segnala un abuso

Segnala un abuso

google translate gb
Sfortunatamente si è verificato un errore, La preghiamo di riprovare più tardi.
B
Perfect 50/60 Hz hum remover
Benedict1966 22.04.2026
My Sequential Prophet REV2 and Korg Prologue 16 outputs were humming. These isolators solved the problem perfectly. No colouring of the sound. Don’t need a power supply. Rock solid and superb quality.
Caratteristiche
Suono
Qualità
0
0
Segnala un abuso

Segnala un abuso