Al contenuto della pagina

Millenium Guitar Clothes Rail Hanger

4.9 su 5 stelle su 29 valutazioni dei clienti

Guitar Holder

  • For hanging guitars and basses on clothes rails
  • Suitable for all standard headstocks
  • Total length: 310 mm
  • Depth: 100 mm
  • Width: 82 mm
  • Maximum neck width: 50 mm

Note: not suitable for guitars with nitro lacquer.

  • In catalogo dal Giugno 2020
  • Numero di articolo 489622
  • Unità incluse 1 Pezzo
  • Materiale Acciaio
  • Tipo Gancio
  • Adatto per: Chitarra acustica, basso elettrico, chitarra elettrica
  • Per chitarre con vernice alla pirossilina No
€ 7
Tutti i prezzi incl. IVA
Disponibile
1

29 Valutazioni dei clienti

4.9 / 5

stabilitá

Qualità

25 Recensioni

A
Appendi chitarre da armadio
Ale80 08.01.2022
Ho dovuto comprare questo prodotto per mettere le mie tre chitarre dentro a un armadio,ho visto tre prodotti simili e alla fine ho optato per questo,sono stato felicissimo per la scelta, dentro un anta di armadio da 45 cm ci sono state le mie tre chitarre,2 acustiche e 1 elettrica,prodotto eccellente come rapporto qualità prezzo!Lo straconsiglio!
Qualità
stabilitá
0
0
Segnala un abuso

Segnala un abuso

f
Good for your wardrobe!
flydiego 26.07.2024
Very useful purchase, now I can hang my guitars inside a wardrobe/cabinet to save space outside.
Qualità
stabilitá
0
0
Segnala un abuso

Segnala un abuso

google translate gb
Sfortunatamente si è verificato un errore, La preghiamo di riprovare più tardi.
K
Saved my wall!
Kamui 28.04.2021
I hung it on iron bars I have as room separators.
Work very well. I purchased 22, and am very satisfied.

The hook is wide enough to hang from most sizes of bars, so I can't imagine there being any sort of an issue in that regard.
Further, if you wish, it could also work as a great installation if you fixate a hook onto the roof, and but this hanger on it. The guitars would float above, would look great.

10/10 recommend.
It is also much cheaper here than on Amazon.
Qualità
stabilitá
1
0
Segnala un abuso

Segnala un abuso

google translate gb
Sfortunatamente si è verificato un errore, La preghiamo di riprovare più tardi.
m
Perfect for me!
mnoach 23.09.2023
I have "a lot" of string instruments, so I needed a solution to hang them, no free wall available. I thought of a mobile "wardrobe" and self-made hangers, a piece of hardwood with a hole for the rail, and a pair of pins (steel with rubber coating) that would fit into a few holes in that little plank. Cheap, but quite some work, even in my fully equipped workshop. I saw these Millenium hangers and ordered 20 of them, enough for the 2.5m long rail. They are great, even though I might shorten a few to gain space below the instruments, where I will store my pedals (a few dozen). I will check the diameter of the steel wire used for the hangers, and, if possible, I will cut one, make it a bit shorter and thread it, after which I will rejoin both parts with a junction nut. Note that I still have to make the rail stand, a 250x45cm board on 5 wheels (one in the middle, given the length), an edge profile formed from hardwood, two 145cm high aluminium profiles and 2.5m galvanised plumbing pipe (3/4") should do the trick. Some triangular foot pieces and black paint (epoxy for the pipe and profiles) should finish the job.
Qualità
stabilitá
0
0
Segnala un abuso

Segnala un abuso