Al contenuto della pagina

Ricevitore D-Fi wireless a batteria

  • Si collega direttamente alla porta XLR del dispositivo
  • Riceve i segnali DMX e master/slave tra dispositivi simili
  • Gli indicatori LED riportano visivamente il funzionamento del canale wireless
  • Funziona senza alimentazione esterna
  • Completamente conforme alle certificazioni FCC/RTTE
  • Distanza massima: 50 m
  • Autonomia massima: fino a 10 ore
  • Tempo di ricarica: 2,5 ore
  • Frequenza di funzionamento: da 2,412 a 2,484 GHz
  • Tensione di ingresso: 5 V DC, 500 mA
  • Autorizzazioni: CE, FCC, RTTE
  • Uscita HF: 12,72 dB
  • Dimensioni: 88 x 27 x 29 mm
  • Peso: 45 g
  • In catalogo dal Maggio 2023
  • Numero di articolo 565414
  • Unità incluse 1 Pezzo
€ 45
Tutti i prezzi incl. IVA
Disponibile
1

41 Valutazioni dei clienti

4.8 / 5

uso

Caratteristiche

Qualità

25 Recensioni

L
Ricevitore DMX da utilizzare con il trasmettitore CHAUVET DJ
LJ_ROB 20.05.2025
Ho comprato questo ricevitore aggiuntivo per aggiungerlo al Chauvet DJ D-Fi XLR Pack.
In questo modo si possono connettere molti fari distanti tra loro eliminando il cablaggio DMX.

I ricevitori funzionano bene, la latenza è trascurabile o inesistente, dipende anche dall'ambiente, dall'altezza dei fari e dalla quantità di gente presente.
Se mettete i fari a terra a distanza con un pubblico enorme, forse il segnale potrebbe diminuire, ma per il momento non ci sono stati problemi.
uso
Caratteristiche
Qualità
0
0
Segnala un abuso

Segnala un abuso

MV
Eccezionali
Mauro Verdoliva 08.07.2025
Ricevono perfettamente il segnale mandato dal trasmettitore della stessa casa. Una sola volta l'ha perso ma per un problema di intasamento risolto cambiando il canale. Buona manifattura, forse i tastini un po' troppo piccoli.
uso
Caratteristiche
Qualità
0
0
Segnala un abuso

Segnala un abuso

google translate gb
Purtroppo si è verificato un errore, ti preghiamo di riprovare più tardi.
I
Small issue so 4 Stars
Irishdj 13.04.2024
Extremely easy to use , build quality on the units themselves is good , battery life is great , BUT one little issue , Charging them !! They are very loose in the charger base and you need to make sure they lights are illuminated (Charging) but is someone was to knock off them slightly they can break contact with the charger base , I’ve seen some posts with people using a bit of paper jammed in the side to keep them in place . Apart from this issue Oh and why only provide 3 receivers… why not 2 or 4 … but 3 🤷🏻
uso
Caratteristiche
Qualità
1
0
Segnala un abuso

Segnala un abuso

google translate gb
Purtroppo si è verificato un errore, ti preghiamo di riprovare più tardi.
N
Reliable wireless DMX, but severely limited update rate
Nickhuge 15.10.2026
I purchased the D-Fi Hub 2 and XLR-RX receivers for a touring lighting rig, but unfortunately found the wireless performance unsuitable for fast-moving, tightly synchronised lighting effects.

After noticing visible stepping during fast chases, I built a test using numbered DMX frames to measure actual throughput rather than relying on the advertised refresh rate.

My results were consistent across multiple tests:

Direct wired DMX: 31 unique frames per second.

Through the Hub 2's wired output: 29–32 unique frames per second, effectively no additional loss.

Through the D-Fi wireless link: Just 11 unique frames per second, with approximately 75% of the original 44 fps source frames lost.

Interestingly, the wireless receiver continued outputting around 38 frames per second, but most were repetitions of previously received data. This means a conventional DMX analyser could report a perfectly respectable refresh rate without revealing the actual limitation.

I repeated the wireless tests six times, including with my nearby Wi-Fi router switched off, different antenna positions and different D-Fi channels. The results were virtually identical every time.

To Chauvet's credit, their technical support was helpful and explained that the limitation relates to the wireless chipset. This appears to be a hardware limitation rather than a defective unit.

For static lighting, slow fades and basic colour changes, the system may work perfectly well. However, for fast chases, pixel effects or tightly synchronised lighting, the effective update rate is a significant limitation.

I'm giving it two stars because the hardware works consistently and the wired output performs well, but I think the wireless throughput limitation deserves much greater prominence in the product specifications.

Unfortunately, I've returned mine and gone back to wired DMX.
uso
Caratteristiche
Qualità
0
0
Segnala un abuso

Segnala un abuso