Con i nostri cookie, vorremmo offrirti la migliore esperienza di shopping possibile, con tutto ciò che ne consegue. Questo include, ad esempio, offerte adatte, annunci personalizzati e il salvataggio delle preferenze. Se per te va bene, acconsenti semplicemente all'uso dei cookie per preferenze, statistiche e marketing cliccando su 'Va bene!' (show all). Il consenso può essere revocato in qualsiasi momento tramite le impostazioni dei cookie (qui)
Devi effettuare il login per poter lasciare una recensione.
IMPORTANTE: Per evitare di inserire informazioni per sentito dire, non complete o sbagliate, permettiamo di dare un giudizio delle attrezzature solo ai nostri clienti che hanno comprato la merce direttamente da noi.
Dopo il Login trovi nella tua area cliente troverete sotto la sezione "Giudica i prodotti" tutti gli articoli ai quali potrete dare un giudizio
Sfortunatamente si è verificato un errore, La preghiamo di riprovare più tardi.
2
Headphone extension
22minx 08.11.2021
Easy to solder, Neutrick high standard. I use it for extending my headphones signal. Works great, lock feature is amazing. Works with 80 and 250 ohm headphones.
Sfortunatamente si è verificato un errore, La preghiamo di riprovare più tardi.
aT
Good but takes some tricks
a Tamás 30.10.2025
Made a 3.5mm to 6.35mm TRS adapter with it.
Pros:
It takes up to 8mm diameter cables without needing a different chuck and boot.
It can do only 2 poles as well, for instance a TS to RCA adapter.
The pins are positioned in a triangle, similarly to an XLR connector, which is easier to solder than tipical pin positions on TRS connectors.
Cons:
The area around the pin cups is plastic and may melt if you get too close with the iron.
The latch lock is very hard to push down - the Neutrik website says it has a locking force of more than 80 Newtons. However, taking out the spring under the red latch lock can make it a lot easier - just slide the bar to the end to lock and slide back to unlock.
The boot is a little difficult to put on without creating a gap between the housing and the connector opening. A workaround is to screw the boot halfway on, then screw the small screw into the housing and then screw the boot fully on.
Sfortunatamente si è verificato un errore, La preghiamo di riprovare più tardi.
J
Neutrik NJ3 FC-6
James007 11.06.2013
These are Neutrik so you can be rest assured with the quality. The locking input works well to avoid the jack slipping out. Bear in mind that this will need soldering but it's pretty easy to do after you've done a few different leads and sockets.